读知识>英语词典>bluing翻译和用法

bluing

n.  烤蓝; 蓝色漂白剂;上蓝剂; 蓝化;烧蓝;模温过高而引起的绿色氧化膜

化学

COCA.46990

英英释义

noun

  • a process that makes something blue (or bluish)
      Synonym:blueing
    1. used to whiten laundry or hair or give it a bluish tinge
        Synonym:blueingblue

      双语例句

      • Study of Basic Bluing Processing
        关于碱性发兰工艺的分析
      • By experiment and further application, it has been proved that wastewater from bluing in electroplating plant could be treated by urea reduction, resulting in removal of NO-2 N more than 99.9% and quality of water discharged conforming to our national discharge standard.
        通过对发兰废水处理方法的研究和实践,提出尿素还原法处理发兰废水是可行的,废水中NO-2-N的去除率达99.9%以上,出水水质达到国家排放标准。
      • Bluing process is discussed.
        论述了常温复合发蓝工艺。
      • A new technology and equipment of annealing and bluing for finished stator and rotor of uncoated cold-rolled electric steel lamination in bell-type hytrogen furnace was introduced.
        介绍了无涂层电工钢冲片叠片成型后的电机定子和转子在罩式炉内进行退火和发蓝处理一次完成的新工艺及装置。
      • Pretreatment, bluing and post treatment of this process were introduced.
        介绍了前处理、发蓝及后处理工序。
      • Summary of Bluing Problem for Ammonium Bicarbonate Fertilizer
        碳铵化肥发青问题解决小结
      • Adhesion, wear and corrosion resistance of the coatings obtained were compared with those of conventional bluing at room temperature.
        测量了发蓝膜的附着力、耐磨和耐蚀性,并与传统常温发蓝进行了对比。
      • The mechanism and treatment process as well as applying effect of bluing in alkaline media and blackening at room temperature for surface treatment of steel parts were contrasted, the optimal conditions and application using two surface treatment methods in the production were obtained.
        本文作者旨在通过两种表面处理方法的形成机理、工艺流程以及运用效果的对比,得出两种方法在生产上的应用范围和适宜条件。
      • The production shows that the best bluing time in normal temperature is from 4 to 8 minutes and bluing film is bright and anti-corrosion capacity is at or higher than the specified state standard.
        生产实践表明,常温发蓝的最佳发蓝时间为4~8分钟,发蓝膜光亮,耐蚀达到并超过国家规定标准。
      • Tapered bores for keyed hubs shall have a minimum of70% transfer of bluing ( surface contact) to the taper gage.
        键槽轮毂的锥孔应至少有70%的着色(表面接触)转移到锥度计上?