indentations
英 [ˌɪndɛnˈteɪʃənz]
美 [ɪnˌdɛnˈteɪʃənz]
n. 缺口; 凹陷; 凹痕; 行首缩进; 行首空格; 造成凹陷(或缺口); 将行首缩进
indentation的复数
柯林斯词典
- 行首缩格,行首留空格
Anindentationis the space at the beginning of a line of writing when it starts further away from the edge of the paper than all the other lines. - N-COUNT 凹口;缺口
Anindentationis a shallow hole or cut in the surface or edge of something.- Using a knife, make slight indentations around the edges of the pastry.
用刀子绕馅饼边沿刻小锯齿。
- Using a knife, make slight indentations around the edges of the pastry.
双语例句
- The varying distance between the microhardness indentations at the blanks of the cracks as a function of applied loads could be monitored to determine the crack opening displacements near the crack tip, which were used to obtain the crack opening load.
通过测量裂尖后两岸显微硬度压痕随裂纹张开闭合的距离变化,建立了缺口根部角裂纹裂尖附近的裂纹张开位移和载荷的关系,以此确定裂纹的张开应力。 - Xtrace: iprint= awt activates method trace and set the output to stderr with indentations.
iprint=mt激活方法跟踪并将输出发送到stderr,进行缩进。 - Study on the Measurement of Residual Stresses around Indentations inSiC/ Al_2O_3 Nanocomposite Using Fluorescence
SiC/Al2O3纳米复合材料压痕残余应力压谱法测量研究 - The house's hooves left deep indentations in the mud.
马蹄在泥地里留下了深深的蹄印。 - A new experimental measurement of residual stresses around Vickers ′ indentations on the surface of the SiC/ Al 2O 3 nanocomposites is proposed with the aid of a Raman microprobe.
提出了用拉曼显微镜测试SiC/Al2O3纳米复合材料表层V氏压痕周围残余应力的新方法。 - Make four indentations into the condenser near the standard cone joint.
在冷凝器接近标准圆锥接头处打四个穴孔。 - Using a knife, make slight indentations around the edges of the pastry.
用刀子绕馅饼边沿刻小锯齿。 - The link of steel sheeting with concrete in a composite deck slab relies on vertical wave troughs and indentations.
对配置横向剪力钢筋的压型钢板-轻骨料混凝土组合楼板的抗滑移性能进行了研究。 - By contrast, most modern word processors let you set tabs and indentations by dragging a marker on a ruler.
相对地,多数当代的文字处理器通过拖放标尺上的标记来设定制表符和缩进。 - PITTED: Small indentations appearing as black dots on finished surfaces of any piece of product; undesirable surface defects.
麻面:在任何成品零件的表面上出现的小的黑色的麻点,这是不希望的缺陷。
