pull-out

英 [ˈpʊl aʊt]

美 [ˈpʊl aʊt]

n.  (报刊等的)可取出插页; (军队的)转移，撤离; (机构的)撤销

复数：pull-outs　

牛津词典

noun

• （报刊等的）可取出插页
  a part of a magazine, newspaper, etc. that can be taken out easily and kept separately
  1. an eight-page pull-out on health
     八页的保健插页
  2. a pull-out guide
     活页指南
• （军队的）转移，撤离；（机构的）撤销
  an act of taking an army away from a particular place; an act of taking an organization out of a system

柯林斯词典

• N-COUNT （报纸或杂志中的）活页
  In a newspaper or magazine, apull-outis a section which you can remove easily and keep.
  1. ...an eight-page pull-out supplement.
     有8页活页的副刊
• N-SING （军队的）撤出，撤退
  When there is apull-out ofarmed forcesfroma place, troops which have occupied an area of land withdraw from it.
  1. ...a pull-out from the occupied territories...
     从占领区撤军
  2. The pull-out of the army paves the way for independence.
     军队的撤出为独立铺平了道路。

双语例句

• This research is aimed to use pull-out test and break-off test to estimate the in-place compressive strength of concrete.
  本研究乃是利用拉拔试验法与弯裂试验法来评估现地混凝土构件之抗压强度。
• Pull-out model test for tunnel anchorage and numerical analysis
  隧道锚围岩拉拔模型试验研究及数值模拟
• The distribution of normal stress in fiber and interfacial shear stress were obtained as well as the axial pull-out force.
  拔出为例，对橡胶-纤维复合材料不同温度下的界面力学性能进行了数值分析，得到了相应的应力场分布和拔出载荷的变化。
• Calculation method of ultimate bearing capacity of vertical pull-out screw pile in soft ground endurance limit on base
  软土地基螺旋桩竖向抗拔极限承载力计算方法
• Regression and analysis of mechanism of pull-out post-anchored method to check concrete strength
  有约束后锚固拔出法试验受力机理及回归曲线分析
• FEM Analysis of the Cyclic Ultimate Pull-out Capacity of the Vertically Loaded Anchor
  法向承力锚循环极限抗拔力有限元分析
• Micromechanical analysis of single-fiber pull-out test of fiber-reinforced elastomer matrix composites
  纤维增强弹性体基复合材料单纤维拔出试验细观力学分析
• Pull-out Experiment on Shear Connector in Embedded Composite Beams with Notched Web
  腹板嵌入式组合梁抗剪连接件拔出试验
• The relationships between the local bond strength obtained by pull-out test and the parameters of non-destructive evaluation are discussed.
  本研究采用拉拔试验试体以讨论高温延烧后钢筋局部握裹力的损失与非破坏检测参数间的关系。
• Combining the pull-out tests on anchor bolts, the feasibility of this method was discussed.
  结合锚杆拉拔试验，分析了这一技术用于锚杆应力状态监测的可行性。