squish

英 [skwɪʃ]

美 [skwɪʃ]

v.  (被)压坏，挤坏; 发吧唧声; 发吱嘎声

过去分词：squished　过去式：squished　现在分词：squishing　第三人称单数：squishes　

BNC.48495 / COCA.19433

牛津词典

verb

• （被）压坏，挤坏
  if sth soft squishes or is squished , it is crushed out of shape when it is pressed
• 发吧唧声；发吱嘎声
  to make a soft wet sucking sound

英英释义

noun

• the noise of soft mud being walked on

verb

• put (a liquid) into a container or another place by means of a squirting action
• walk through mud or mire
  1. We had to splosh across the wet meadow
  Synonym:squelchsplashsploshsloshslop

双语例句

• The air motion in UCS combustion system is much stronger than that in base combustion system and the strong reversed squish lasts longer in the former than in the latter because the former has a far larger squish area than the latter.
  伞帘喷雾燃烧系统的挤气面积远大于原机，因此前者的空气运动明显强于后者，较强逆挤流维持的时间长于后者。
• The reversed squish is mainly concentrated at the edge of the combustion chamber.
  逆挤流主要发生在燃烧室边缘；
• During the compression stroke the turbulence kinetic energy decreases due to the dissipation effect, while the turbulence kinetic energy in the center of the cylinder increases as a result of the squish effect.
  缸内平均湍动能强度在进气冲程中总体呈先增大后减小的趋势，压缩冲程中耗散作用使湍动能降低，但挤流作用使气缸中部的湍动能升高；
• Study on Combustion Chamber Squish Velocity and Heat Release in a Moped 2-stroke Engine
  二冲程汽油机燃烧室挤流和放热规律的研究
• The squish patterns in engine piston bowls with different geometry are visualized by the method of oil streak in a motored single cylinder test engine.
  本文在一个拖动的单缸实验机上，利用油点条痕法显示了活塞上燃烧室凹坑中挤流运动的流谱，研究了燃烧室形状和几何尺寸对挤流谱的影响。
• Reversed squish is mainly concentrated at edge of combustion chamber bowl.
  反喷或逆挤流主要集中在燃烧室边缘上。
• This filter, under the "Filters" menu, allows you to move, smudge, squish, and otherwise distort your image.
  这种过滤器，在“过滤器”菜单，允许您移动，涂抹，果酱，并扭曲的形象。
• And, then we squish all of them up, and that's how we get the contour plot OK, so each of these lines, imagine that this is like some mountain or something that you are hiking on.
  然后把所有等高线聚合到一起，这样就得到了等高线图，对于每一条这些线，想象，你是在爬山或是徒步旅行。
• As the small and medium sized high-speed direct injection diesel engine needs strong intake swirl, squish compression and combustion turbulence, its intake port generally made spiral or tangential shape.
  对于中小型高速直喷式柴油机，因其需要较强的进气涡流、压缩挤流和燃烧紊流，其进气道一般做成螺旋的或切向的形状。
• You may have to squish it a little in one or more directions to break it loose.
  您可能口都得它在一个或多个方向的一点打破它松散。